Published by admin on 11 Jul 2008 at 10:35 pm
MPLS Lab
This is an MPLS LAB design running under Dynamips.
It consists of 2 Customers, Customer A and Costomet B, each customer has 4 sites located in different areas, each of these sites have their own CE router, customer A has (CE11A, CE12A, CE21A and CE22A) customer B has (CE11B, CE12B, CE21B and CE22B)
The 4 areas are called POP1, POP2, POP3 and POP4. Each area has its own PE router (PE11, PE12, PE21 and PE22).
Each PE is connected to its own P router in the core network (P11, P12, P21 and P22).
P11 and P12 are connected to each other, P21 and P22 are connected to each other.
All P routers are also connected to a final P router (P1).
The Dynamips setup I have used connects all the routers to a single Frame Relay switch which is configured to connect the routers in the correct topology, discribed above and shown below.
This page has the following sub pages.
- MPLS LAB Dynagen network
- Initial Setup - 1
- Establish the MPLS Core - 2
- Initial MPLS VPN Setup - 3
- Running EIGRP between PE and CE - 4
- Running OSPF Between PW and CE - 5
- Running BGP between PE and CE - 6
- Establishing Overlapping VPN’s - 7
- Merging Service Providers - 8
- Establishing a Common Services VPN - 9
- Establishing Central Site Internet with an MPLS VPN - 10
- Implementing Basic MPLS TE - 11